How to change Developer:
Remove cover after removing two screws on the developer unit. Replace the developer with a new one and run the following simulation:
Press 3 and 6 simultaneously and turn the machine ON.
Select HV adjustment,
Press Next untill you see "L Detection"
Press the start key.
Machine should display "OK".
Do not perform this process if you are not a technician.
Copy Quality Adjustment:
You may adjust copy density within the "36" mode.
Common Error messages:
E18-1
Upper paper feed lift problem
E18-2
Lower paper feed lift problem
E18-3
Lower DB lift problem
E22-1
Drum temperature too high
E23-2
PCL connector problem
E26-1, -2, -3
Toner detection problem
F28-1
Charge corona problem
E28-2
Transfer Corona problem
E34-1
High fuser temperature problem, bad thermister
F 18-1
Upper paper feed lift problem
F 26-1
Toner density level is low. No toner.
F 28-1
Charge Corona problem, check any leakage
F 34-2
High Fuser Temperature
E35-1, 35-6
Low fuser temperature
F36-3
Open thermistr1.
F 37-1
Replace fuser cleaning web and reset the web counter in 36 mode.
How to reset Fusing Codes:
Press 2 and 5 simultaneously and turn on the machine ON. Dip swich 3, bit 1 is the fuser reset command, change 0 to 1, and press "ON".